Kambrook KFH200 User Manual download pdf (Page 5)

8 9

Using Your Upright Fan Heater

NOTE: To avoid an electrical

circuit overload, it is

recommended that no other

appliances are plugged into

the same circuit as your heater,

when it is in use.

Setting the Heating Mode

To control the heater, turn the Heat

Setting dial as follows.

The Heat Setting dial has 4 modes:

O - Shuts off the heater and fan

- For fan only operation

I - Low heat setting (1200 watts)

II - High heat setting (2400 watts)

Turn the heater off by turning the

Heat Setting dial to the ‘0’ position.

NOTE: This heater features a

tip-over switch. If the heater tips

over, it will automatically switch

off. Once placed back into the

upright position, the heater will

automatically switch on again.

ThermoGuard Overheating

Safety Device

Your heater is ﬁtted with a safety

device that switches off the heater

in the event of overheating. Should

this heater stop working, turn off the

heater and inspect the air inlet and

outlet for blockages. Wait at least ﬁve

minutes for the protection system to

reset before attempting to restart

the heater.

If the heater fails to operate or the

safety device switches off again,

return the heater to your nearest

Kambrook service centre for

examination or repair.

Before First Use

Remove any promotional material

and packaging from the heater.

Unwind the cord to its full length

and place the heater on a ﬁrm, level

surface in a stable, upright position.

Visually inspect the air inlet and outlets

to ensure there are no blockages.

Turning Your Heater On

Ensure the Heat Setting dial is turned

to ‘0’ for OFF position.

Plug the cord into a 230V or 240V

power point and switch on.

1 2 3 4 5 6

Comments to this Manuals

No comments