Kambrook SNUGASABUG KRH100 User Manual download pdf (Page 9)

8

Before First Use

Remove your heater from its carton

and associated protective wrapping.

Unwind the cord to its full length and

remove any protective cardboard or

foam that may have been used to

minimise transportation damage.

Place the heater on a ﬁrm, level

surface in a stable upright position.

Visually inspect the air inlet and

outlets to ensure no foreign material is

blocking these areas.

Turning Your Heater On

Plug the cord into a 230V or 240V

electrical outlet. Be sure the plug

ﬁts tightly as a loose ﬁt will cause

overheating and damage the plug.

NOTE: To avoid an electrical

circuit overload, it is

recommended that no other

appliances are plugged into the

same circuit with your heater

when you switch the unit on.

• The heater has 2 quartz elements

which are controlled by two

switches located at the back of

the heater.

• To turn the heater ON, select the

desired switch setting.

• Switching ON only the ‘BOTTOM

ELEMENT’ or ‘TOP ELEMENT’,

the heater will be in MEDIUM

heat mode.

• Switching ON both the ‘BOTTOM

ELEMENT and ‘TOP ELEMENT’, the

heater will be in HIGH heat mode.

• To turn the heater OFF, switch all

switches to the ‘OFF’ position.

Using Your Kambrook Heater

ThermoGuard Overheating

Safety Device

Your heater is ﬁtted with a safety

device that switches off the heater

in the event of overheating. Should

this heater stop working, turn off the

heater and

return the heater to your

nearest service centre for examination

or repair.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments