Kambrook KFA413 User Manual download pdf (Page 6)

6

Using Your Kambrook Arctic Pedestal Fan

Before First Use

Remove any promotional material from

the fan.

IMPORTANT: When

unpacking the fan, check

to see you have received

all the items listed in the

Parts List, before discarding

the packaging.

Assembling Your Arctic

Pedestal Fan

Base and Pedestal Tube Assembly

1. Remove the four screws from the

criss-cross bars, and align these

four holes with those on the ﬂange.

Secure the ﬂange to the criss-cross

bars with the four screws. This might

require a bit of force.

Fig. 1

2.

Loosen the Height Adjustable Ring

and extend the support tube. A bit

of force may be required to grasp

the support tube, located inside the

Pedestal Extension Tube. Retighten

the Height Adjustment Ring to

prevent slipping.

3. Place the motor head housing onto

the Pedestal Extension Tube.

4. Tighten the screw to secure the

Pedestal Extension Tube to the

motor head housing.

Fan Head Assembly

1. Remove the Blade Cap from the

Motor shaft by turning it clockwise,

and then remove the Guard Locking

Nut by turning it anti-clockwise.

2. Thread the Motor shaft through

the centre hole of the Rear Grille,

placing the Rear Grille into position.

Make sure that the carry handle, on

the back of the Rear Grille is located

above the motor housing. Ensure

the Rear Grille is aligned with the

locating pins and ﬁx the grille into

position by replacing the Guard

Locking Nut. Make sure that the Rear

Grille has not slipped off the locating

pins before tightening. This should be

done by hand. Do not force.

NOTE: When positioning the

Rear Grille on the Motor shaft,

always ensure the carry handle

on the grille is positioned in the

upright position.

3.

Insert the Plastic Blade onto the

Motor shaft, and match the pin slots

in the blade with the Motor shaft pin.

4. Fix the blade into place by

tightening the Blade Cap onto the

Motor shaft in an anti-clockwise

direction. This should be done by

hand. Do not force.

5. Unlatch the Securing Clips on the

Front Grille and unscrew the small

screw located at the bottom of the

front guard.

6. Press together the Front and Rear

Grille, and secure by snapping shut

the Securing Clips over edges of

both grilles. Make sure that the small

holes at the bottom of both grilles

are aligned. Tighten the Securing

Clips by hand.

7. Thread the screw through the

small holes of both the front and

back grilles, and tighten using the

nut provided.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments